Air Deflector

Air Deflector

Removal and Installation

NOTE: If required, there is a special service replacement fastener available if a screw hole becomes stripped during installation. For additional information, refer to Roof Opening Panel - Exploded View Roof Opening Panel - Exploded View.

1. Position the roof opening panel glass to the full OPEN position.

2. Remove the 2 air deflector-to-track screws and air deflector arm capture plate.

- NOTE: If the nut plate(s) becomes stripped during installation, a new nut plate can be installed. For additional information, refer to Roof Opening Panel - Exploded View Roof Opening Panel - Exploded View.

To install, tighten to 2 Nm (18 lb-in).





3. Remove the 6 air deflector catcher bracket screws.
- To install, tighten to 2 Nm (18 lb-in).





4. Remove the air deflector assembly.

5. To install, reverse the removal procedure.