Camshaft Position Sensor: Service and Repair

Camshaft Position (CMP) Sensor













Removal and Installation

RH sensor

1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.

LH sensor

2. Remove the ACL assembly. For additional information, refer to Fuel Delivery and Air Induction.

Both sensors

3. Disconnect the Camshaft Position (CMP) electrical connector.

4. Remove the bolt and the CMP sensor.
- To install, tighten to 10 Nm (89 lb-in).

5. NOTE: Lubricate the CMP O-ring seal with clean engine oil.

To install, reverse the removal procedure.