Window Glass - Rear Door
Window Glass - Rear Door
Removal and Installation
NOTE: LH shown, RH similar.
1. Remove the door trim panel.
2. Reconnect the window control switch.
3. Lower the window until the glass clamp bolt can be accessed through the access hole, then loosen the glass clamp bolt.
- To install, tighten to 9 Nm (80 lb-in).
4. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
5. Remove the rear door glass interior weatherstrip.
6. Remove the rear door window glass lower fixed window screw.
7. Remove the rear door window glass upper fixed window screw.
8. Position the top run aside as shown.
9. NOTE: Protect the painted surfaces of the vehicle.
With the aid of an assistant (holding the glass in a lowered position to allow clearance), carefully pull the top of the bracket forward slightly, then upward and completely out of the door towards the inside of the vehicle.
10. Slide the glass down, tilt and bring the glass back through the top of the window opening and remove the glass from the door.
11. To install, reverse the removal procedure.