Operation CHARM: Car repair manuals for everyone.
Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously

Pinpoint Test H: DTC U0155




Parking Aid

Pinpoint Tests

Pinpoint Test H: DTC U0155

Normal Operation

Several modules receive network messages from the Instrument Cluster (IC) via the Medium Speed Controller Area Network (MS-CAN). The following information is included in the messages:

- Transmission gear selected
- Vehicle speed
- Parking aid enable command

As more than one module receives these messages, all modules receiving a particular message should exhibit a symptom if the message is missing.

- DTC U0155 (Lost Communication With Instrument Panel Cluster (IC) Control Panel) - set by the Parking Aid Module (PAM) when network messages are missing from the IC for greater than 5 seconds with the ignition in RUN.

This pinpoint test is intended to diagnose the following:

- Module communication
- PAM
- IC



PINPOINT TEST H: DTC U0155

-------------------------------------------------
H1 VERIFY THE CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to H2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or intermittent fault condition.

-------------------------------------------------
H2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the IC pass the network test?

Yes
GO to H3.

No
REFER to Information Bus to diagnose the IC does not respond to the scan tool.

-------------------------------------------------
H3 RECHECK THE PAM DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the PAM self-test.
- Is DTC U0155 still present?

Yes
GO to H4.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic.

-------------------------------------------------
H4 CHECK FOR DTC U0155 SET IN OTHER MODULES


- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0155 set in any module?

Yes
INSTALL a new IC. REFER to Instrument Panel, Gauges and Warning Indicators. TEST the system for normal operation.

No
INSTALL a new PAM. REFER to Parking Aid Module (PAM) Service and Repair. TEST the system for normal operation.

-------------------------------------------------