Exhaust Flexible Pipe

Exhaust Flexible Pipe

Removal and Installation

NOTICE: Do not excessively bend, twist or allow the exhaust to hang from the flexible pipe or damage to the exhaust system may occur.

1. NOTE: Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting. Vehicle Lifting

2. Remove and discard the 2 exhaust flexible pipe-to-exhaust Y-pipe nuts.
- Discard the gasket.

- To install, tighten to 40 Nm (30 lb-ft).

3. Remove the Torca(R) clamp. For additional information, refer to Torca(R) Clamp Torca(R) Clamp.

4. Separate the exhaust flexible pipe isolator and remove the exhaust flexible pipe.

5. To install, reverse the removal procedure.
- Install a new gasket and nuts.

6. Start the engine and check for exhaust leaks.