Lower

Transaxle Support Insulator - Lower

Removal and Installation

Transaxle Support Insulator - Lower









1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Turn the ignition to the OFF position.

3. Remove the splash shield retainers and remove the LH splash shield.





4. Remove the bolts and the lateral support crossmember.
- To install, tighten to 115 Nm (85 lb-ft).





5. Remove the lower insulator through bolt.
- To install, tighten to 115 Nm (85 lb-ft).





6. Remove the rear roll restrictor-to-crossmember through bolt.
- To install, tighten to 90 Nm (66 lb-ft).





7. Remove and discard the engine support crossmember nut. Remove the 2 engine support crossmember bolts.
- To install, tighten the new engine support crossmember nut to 175 Nm (129 lb-ft).

- To install, tighten the 2 engine support crossmember bolts to 90 Nm (66 lb-ft).





8. Remove the engine support crossmember.

9. Remove the rear roll restrictor through bolt and remove the rear roll restrictor from the bracket.
- To install, tighten to 90 Nm (66 lb-ft).





10. To install, reverse the removal procedure.