Transaxle Support Insulator - LH

Transaxle Support Insulator - LH













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the Air Cleaner (ACL). For additional information, refer to Fuel Delivery and Air Induction.

3. Using the Engine Support Bar and Adapters, support the engine.





4. Remove the 4 LH transaxle support insulator bolts.
- To install, tighten to 48 Nm (35 lb-ft).

5. Remove the through bolt and the LH transaxle support insulator.
- To install, tighten to 103 Nm (76 lb-ft).

6. Remove the 3 nuts and the LH transaxle support insulator bracket.
- To install, tighten to 40 Nm (30 lb-ft).

7. To install, reverse the removal procedure.