Seat Backrest - Second Row, 20 Percent

Seat Backrest - Second Row, 20 Percent

Disassembly and Assembly

NOTE: For parts identification and locations, refer to Seat - Exploded View, Second Row Seat - Exploded View, Second Row.

1. Remove the seat backrest. For additional information, refer to Seat Backrest - Second Row, 20 Percent Seat Backrest - Second Row, 20 Percent.

2. Remove the safety belt guide cover.
- Insert an appropriate tool into the holes and release the 3 locking tabs.

- Detach the safety belt guide cover.

- Route the safety belt webbing through the slot.

3. Remove the latch release handle bezel.
- Release the upper tab and separate the bezel from the latch release handle.

4. NOTICE: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the backrest foam pad.

Separate the hook-and-loop strips and invert the backrest trim cover to the row of hog rings.

5. Remove all hog rings.

6. Continue inverting and remove the backrest cover.
- Route the safety belt webbing through the backrest cover opening.

7. Remove the 2 pin-type retainers and foam pad.

8. Remove the safety belt retractor foam cover.

9. Remove the 2 screws and safety belt retractor cover.

10. Remove the safety belt retractor bolt.
- To install, tighten to 40 Nm (30 lb-ft).

11. Release the 2 tabs and detach the safety belt retractor guide.





12. Remove the safety belt retractor.
- Route out the safety belt webbing, guide, tongue and anchor through the backrest frame.

- Note safety belt routing for correct installation.

13. Release the pin-type retainer and detach the release cable from the backrest frame.

14. Remove the 2 screws, latch release handle and route out the cable.
- Note cable routing for correct installation.

15. Remove the 2 pin-type retainers and 2 attaching straps.

16. Remove the 8 backrest support panel screws.

17. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To assemble, reverse the disassembly procedure.