Acceleration/Deceleration Sensor: Service and Repair

Stability Control Sensor Cluster













Removal and Installation

Vehicles with floor shift

1. Remove the front floor console. For additional information, refer Instrument Cluster / Carrier &/or Interior Moulding / Trim.

2. Remove the 4 bolts and the front floor console support bracket.
- To install:
- Tighten the upper bolts to 9 Nm (80 lb-in).

- Tighten the lower bolts to 40 Nm (30 lb-ft).





Vehicles with column shift

3. Remove the stability control sensor cover.

All vehicles

4. Disconnect the stability control sensor cluster electrical connector.

5. Remove the 2 bolts and the stability control sensor cluster.
- To install, tighten to 12 Nm (106 lb-in).

6. To install, reverse the removal procedure.
- Connect the scan tool and carry out the IVD Initialization sequence.