Selector Lever Bezel

Selector Lever Bezel

Expedition









Navigator









Removal

Expedition

1. Remove the selector lever trim ring, console tray and cup holder insert.





2. Remove the screw and the console upper trim.





Navigator

3. Remove the selector lever trim ring.





4. NOTE: Using a suitable tool, lift and remove the floor console upper panel from the rear.

Remove the floor console upper panel.





All vehicles

5. Remove and discard the RH selector lever knob cover.

1. Start at the bottom front only.

2. Move towards the top front and remove the cover.





6. Remove and discard the LH selector lever knob cover.

1. Start at the bottom front only.

2. Move towards the top front and remove the cover.





7. Remove and discard the RH selector lever knob screw.





8. NOTE: Verify the LH and RH knob body towers are present and not damaged.

Remove and discard the LH selector lever knob screw.





9. Disconnect the tow/haul switch electrical connector and remove the selector lever knob.





10. Lift the tabs on the selector lever bezel and lift the bezel for access to the electrical harness.





Expedition

11. Disconnect the electrical harness from the bezel.





Installation

Expedition

1. Connect the electrical harness onto the bezel.





All vehicles

2. Align the brake shift interlock override tab into its guide.





3. Install the selector lever bezel onto the selector lever housing.





4. Connect the tow/haul switch electrical connector and install the selector lever knob.





5. Install a new LH selector lever knob screw.
- Tighten to 2 Nm (18 lb-in).





6. Install a new RH selector lever knob screw.
- Tighten to 2 Nm (18 lb-in).





7. NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.

Install a new LH selector lever knob cover.





8. NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.

Install a new RH selector lever knob cover.





Expedition

9. Install the console upper trim and the screw.





10. Install the selector lever trim ring, console tray and cup holder insert.





Navigator

11. Install the floor console upper panel.





12. Install the selector lever trim ring.