5R55S

Transmission Support Insulator - Four Wheel Drive (4WD)









Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. If equipped, remove the skid plate bolts and the skid plate.

3. Support the transmission with a transmission jack.

4. Remove the 2 transmission support insulator-to-crossmember nuts.





5. NOTE: Crossmember and exhaust system removed for clarity.

NOTE: LH shown, RH similar.

Remove the 2 transmission support insulator-to-extension housing screws.





6. Raise the transmission and remove the transmission support insulator.

Installation

1. Install the transmission support insulator and the 2 transmission support insulator-to-extension housing screws.
- Tighten to 90 Nm (66 lb-ft).





2. Lower the transmission and install the 2 transmission support insulator-to-crossmember nuts.
- Tighten to 90 Nm (66 lb-ft).





3. If equipped, install the skid plate and skid plate bolts.
- Tighten to 24 Nm (18 lb-ft).