Compressor To Condenser Discharge Line

Compressor to Condenser Discharge Line - 4.6L













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Recover the refrigerant.

3. Remove the Air Cleaner (ACL) and ACL outlet tube. For additional information, refer to Service and Repair

4. Remove the compressor-to-condenser discharge line bracket nut and detach the bracket.
- To install, tighten to 9 Nm (80 lb-in).

5. Remove the compressor outlet fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

6. Remove the 2 coolant expansion tank bolts and position the coolant expansion tank aside.
- To install, tighten to 7 Nm (62 lb-in).

7. Disconnect the A/C pressure transducer electrical connector.

8. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal.

- To install, tighten to 8 Nm (71 lb-in).

9. NOTE: The LH clip should be disconnected from the line. The RH clip should be disconnected from the cooling module.

Detach the 2 compressor-to-condenser discharge line clips at the cooling module.

10. Remove the compressor-to-condenser discharge line.

11. To install, reverse the removal procedure.
- Install a new gasket seal and O-ring seals.

- Lubricate the refrigerant system with the correct amount of clean PAG oil.

12. Evacuate, leak test and charge the refrigerant system.