Pinpoint Tests BA: DTC U0244

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test BA: DTC U0244

Normal Operation
- DTC U0244 (Lost Communication With Running Board Control Module ( PRB)) - sets in continuous memory if data messages received from the Power Running Board (PRB) module over the Medium Speed Controller Area Network (MS-CAN) are missing for greater than 5 seconds.

This pinpoint test is intended to diagnose the following:

- PRB module
- Instrument Cluster (IC)



PINPOINT TEST BA: DTC U0244

-------------------------------------------------
BA1 VERIFY THE CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to BA2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
BA2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the PRB module pass the network test?

Yes
GO to BA3.

No
REFER to Information Bus.

-------------------------------------------------
BA3 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST


- Check for recorded IC DTCs from the self-test.
- Is DTC B1317 or DTC B1318 recorded?

Yes
GO to Pinpoint Test AN (B1317) or GO to Pinpoint Test AO (B1318). Pinpoint Tests AN: DTC B1317 Pinpoint Tests AO: DTC B1318

No
GO to BA4.

-------------------------------------------------
BA4 RECHECK THE IC DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the IC self-test.
- Is DTC U0244 still present?

Yes
INSTALL a new PRB module. REFER to Auxiliary Step / Running Board. CLEAR the DTCs. REPEAT the IC self-test.

If DTC U0244 is still present, INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------