Selector Lever Cable Adjustment - Floor Shift

Selector Lever Cable Adjustment - Floor Shift

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Place the selector lever in the 1st gear position.

3. Move the selector lever 3 detents to the (D) position.

4. Do not remove the heat shield.





5. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket.

Rotate the cable adjustment lock upward and remove the selector lever cable from the manual control lever.





6. Place the manual control lever in the (D) position.
- Place the manual control lever in the 1st gear position.

- Move the manual control lever 3 detents to the (D) position.





7. NOTE: Apply pressure to the selector lever cable end while installing it onto the manual control lever and make sure the selector lever and manual control lever has not moved out of the (D) position.

Install the selector lever cable onto the manual control lever and rotate the lock downward to lock the adjuster.





8. Verify the vehicle will start in PARK or NEUTRAL and the backup lamps illuminate in REVERSE. If the vehicle will not start or the backup lamps do not illuminate, the selector lever cable adjustment steps must be repeated.
- Readjust if necessary.