Oil Pressure Sender: Service and Repair

Engine Oil Pressure (EOP) Switch









Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.

3. Remove the EOP switch.

Installation

1. Install the EOP switch and tighten in 2 stages.
- Stage 1: Tighten to 14 Nm (125 lb-in).

- Stage 2: Tighten an additional 180 degrees.

2. Connect the EOP switch electrical connector.