Bumper - Rear

Bumper - Rear

Removal and Installation

1. Disconnect the license plate lamp harness from the rear bumper.





2. If equipped, disconnect the rear park aid harness.

3. Remove the 4 rear bumper-to-bracket nuts.
- To install, tighten to 115 Nm (85 lb-ft).





4. NOTE: The aid of an assistant is required to remove the bumper.

Remove the 2 rear bumper bolts and retainers (1 each side).

5. Remove the rear bumper from the vehicle.

6. To install, reverse the removal procedure.
- Transfer all necessary components.