150000 MI or 240000 KM

Lubricate
    Steering and Suspension
      Lubricate steering linkage, ball joints, suspension, tie rod ends, drive shaft, 4x4 front axle U-joints and U-joints (lubricate if equipped with Zerk fittings)
Inspect
    Vehicle
      Check and top up fluid levels: brake, coolant recovery reservoir, fuel coolant recovery reservoir, manual and automatic transmission, power steering and window washer. Inspect tires for wear and check air pressure, including spare. Check exhaust system for leaks, damage, loose parts, and foreign material. Check that holes in the tail-pipe of the exhaust system are clear of debris; the holes/slots are functional. Check battery performance. Check operation of horn, exterior lamps, turn signals and hazard warning lights. Check radiator, coolers, heater and air conditioning hoses. Inspect windshield washer spray and wiper operation. Check windshield for cracks, chips and pitting. Inspect for oil and fluid leaks. Inspect engine air filter. Check shocks and struts and other suspension components for leaks and damage.
    Fluid - A/T
      Inspect automatic transmission fluid level on all vehicles equipped with the Torqshift transmission.
    Air Filter Restriction Sensor / Switch
      Inspect air filter restriction gauge, replace filter as required.
Replace
    Oil Filter, Engine
    Fluid - Transfer Case
    Fluid - Differential
      Change front axle fluid (4WD vehicles). Change rear axle fluid (DANA axles only).
    Engine Oil
    Drive Belt
      Replace accessory drive belt if not replaced in the last 100,000 miles (160,000 km).
    Coolant
      Change coolant and fuel coolant.
Rotate
    Tires
      Rotate tires, inspect for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only rotate if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.