Tremec 5-Speed

Gearshift Lever and Boot





Removal and Installation

1. Remove the 2 screws under the shift lever boot and slide the shift boot back, unseating it from the front tab.





2. Slide the upper shifter boot assembly up the shift handle to access the 2 shift handle bolts.

- NOTE: Apply threadlock to the bolt threads during installation.

Remove the 2 shift handle bolts and lever.

- To install, tighten to 28 Nm (21 lb-ft).





3. Remove the 4 bolts and the lower gearshift lever.
- To install, tighten to 11 Nm (97 lb-in).





4. To install, reverse the removal procedure.