Tool Link(TM) Reader

Tool Link(TM) Reader









Removal and Installation

1. Remove the in-dash computer. For additional information, refer to In-Dash Computer In-Dash Computer.

2. Locate and cut the power feed wire for the Tool Link(TM) reader.

3. Remove the LH screw from the connector box bracket and remove the Tool Link(TM) reader ground eyelet.

4. Remove the LH front and rear sill panels to access the Tool Link(TM) reader electrical harness.

5. Remove the 4 screws and the Tool Link(TM) reader.
- Disconnect the electrical connectors.

6. To install, reverse the removal procedure.

1. Route the new power/ground feed electrical harness along the LH sill panel to the connector box in the instrument panel.

2. Splice the power feed into the existing feed that was cut during the removal procedure.

3. Position the ground eyelet and install the LH connector box screw.