Accessory Protocol Interface Module (APIM)

Accessory Protocol Interface Module (APIM)









Removal and Installation

1. Remove the Front Display Interface Module (FDIM) refer to Front Display Interface Module (FDIM) Front Display Interface Module (FDIM).
- Disconnect the electrical connectors.

2. Remove the 4 screws and remove the Accessory Protocol Interface Module (APIM) from the FDIM.
- To install, tighten to 0.6 Nm (5 lb-in).

3. To install, reverse the removal procedure.
- If a new APIM is being installed, program the APIM to the correct software level. For additional information, refer to Accessory Protocol Interface Module (APIM) Programming in Module Configuration Testing and Inspection.