Shift Cable: Service and Repair

Selector Lever Cable









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Place the selector level in the D position.





3. Gently pry up to remove the upper selector lever trim ring.





4. Lift the center console lid and remove the center console compartment tray.





5. Remove the top finish panel.





6. Remove the selector lever cable from the selector lever assembly.

1. Disconnect the selector lever cable end from the selector lever.

2. Remove the selector lever cable from the bracket.





7. Remove the 2 grommet nuts for the selector lever cable.
- To install, tighten to 10 Nm (89 lb-in).





8. Remove the selector lever cable retainer from the transmission fluid filler tube.





9. Disconnect the selector lever cable end from the manual control lever.





10. Release the 2 tabs and remove the selector lever cable from the selector lever cable bracket.





11. To install, reverse the removal procedure.
- Adjust the selector lever cable after installation. For additional information, refer to Selector Lever Cable Adjustment Adjustments.