Transaxle Support Insulator - Lower, Rear

Transaxle Support Insulator - Lower, Rear









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. NOTE: All-Wheel Drive (AWD) shown, Front Wheel Drive (FWD) similar. Vehicles equipped with AWD have a damper that is held on by the through bolt.

Remove the lower support insulator.

1. Remove the lower support insulator through bolt.
- To install, tighten to 115 Nm (85 lb-ft).

2. Remove the lower support insulator bolt and 2 nuts.
- To install, tighten to 80 Nm (59 lb-ft).

3. Remove the lower support insulator.





3. If necessary, remove the 3 bolts and the lower support insulator bracket.
- To install, tighten to 80 Nm (59 lb-ft).

4. To install, reverse the removal procedure.