Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure (MAP) Sensor













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the Throttle Body (TB). For additional information, refer to Fuel Charging and Controls - Hybrid Service and Repair.

3. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector.

4. Using a tool like KD Tool #58181 or Lisle T25 Torx Bit, remove the screw and the MAP sensor.
- To install, tighten to 3 Nm (27 lb-in).

5. NOTE: Lubricate the MAP sensor O-ring seal with clean engine oil.

To install, reverse the removal procedure.