Ignition Switch: Service and Repair

Ignition Switch









Removal and Installation

NOTICE: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column may result.

1. Depower the Supplemental Restraint System (SRS). For additional information, refer to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

2. Remove the steering column opening trim.

3. Remove the 3 lower steering column shroud screws.

4. Remove the upper and lower steering column shrouds. For additional Information, refer to Steering Column Steering Column Shroud

5. Disconnect the ignition switch electrical connector.

6. Remove the ignition switch by pressing the 2 tabs and pulling the ignition switch outward.

7. To install, reverse the removal procedure.

8. Repower the SRS. For additional information, refer to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.