NVH Shield

NVH Shield

Transaxle NVH Shield









1. Disable the high voltage electrical system. For additional information, refer to High Voltage Traction Battery .

2. Remove the rear transmission insulator bracket. For additional information, refer to Transaxle Support Insulator - Rear Rear.

3. Remove the wiring harness retainer and selector lever cable from the studs.





4. Remove the NVH shield stud.
- To install, tighten to 9 Nm (80 lb-in).





5. Remove the 2 transaxle harness electrical connector bracket bolts.
- To install, tighten to 9 Nm (80 lb-in).





6. Remove the stud bolt and disconnect the transaxle harness electrical connector.
- To install, tighten to 10 Nm (89 lb-in).





7. Remove the 2 nuts from the bottom of the NVH shield.
- To install, tighten to 9 Nm (80 lb-in).





8. Remove the NVH shield.

9. To install, reverse removal procedure.