Stub Shaft Seal

Stub Shaft Seal









Removal

1. NOTE: There is no bearing for the stud shaft. There is a seal only.

Remove the halfshaft assembly. For additional information, refer to Rear Drive Halfshafts Rear Drive Halfshafts.

2. Use the Torque Converter Fluid Seal Remover and Slide Hammer to remove the stub shaft seal.





Installation

1. NOTE: Lubricate the new stub shaft seal with grease.

Using the Front Axle Oil Seal Installer and Handle, install the stub shaft seal.





2. NOTE: Inspect the inboard CV joint seal journal for rust or nicks/scratches prior to installing the halfshaft. If necessary, polish the seal journal with fine crocus cloth.

Install the halfshaft assembly. For additional information, refer to Rear Drive Halfshafts Rear Drive Halfshafts.