Exterior Mirror Glass

Exterior Mirror Glass

Removal and Installation

NOTICE: Failure to correctly remove the exterior mirror glass may result in exterior mirror motor damage.

NOTE: If equipped with power folding mirrors, they must be synchronized any time the mirrors have been folded or unfolded without using the mirror control switch. For additional information, refer to Exterior Mirror Motor Synchronization - Power Folding Programming and Relearning.

1. Position the exterior mirror glass to the full upward and inboard position and insert a thin flat-blade screwdriver.





2. WARNING: Place a shop towel between the hands and the exterior mirror glass for protection in case of glass breakage during mirror service. Failure to follow this instruction may result in serious personal injury.

NOTE: LH mirror and motor shown removed from the housing and from the back to show location of clips and placement of screwdriver.

Using a then flat-blade screwdriver, release the tabs starting at the lower outboard side of the exterior mirror and continue to the lower inboard side. Remove the exterior mirror glass.





3. Disconnect the electrical connectors and remove the glass.

4. To install, reverse the removal procedure.
- Rotate the exterior mirror glass in all directions after the installation to make sure all clips are completely attached.

- If equipped with power folding mirrors, they must be synchronized. For additional information, refer to Exterior Mirror Motor Synchronization - Power Folding Programming and Relearning.