Power Seat Control Module: Service and Repair

Driver Seat Module (DSM)

Removal and Installation

NOTICE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to a scan tool. This information must be downloaded into the new Driver Seat Module (DSM) after installation. For additional information, refer to Module Configuration Programmable Module Installation (PMI).

1. NOTE: This step is only necessary if the DSM is being replaced.

Upload the module configuration information from the DSM into the scan tool. For additional information, refer to Module Configuration Programmable Module Installation (PMI).

2. NOTE: The module is accessed with the seat fully in the UP position.

Position the DSM forward to remove it from the bracket.

3. Disconnect the electrical connectors and remove the DSM.

4. NOTE: Once the DSM is installed (if it was replaced), it is necessary to download the module configuration information from the scan tool into the new DSM. For additional information, refer to Module Configuration Programmable Module Installation (PMI).

To install, reverse the removal procedure.