Seat Cushion - Front

Seat Cushion - Front

Disassembly and Assembly

NOTE: If a new Driver Seat Module (DSM) has been installed, all seat and power tilt column (if equipped) soft stops must be reset. If a new seat track, recline motor or power tilt column has been installed, only reset the soft stops for that component being installed new. To set the soft stops, refer to Principles of Operation. Principles Of Operation

NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

All seats

1. Remove the seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front Removal and Installation.

2. Remove the seat cushion cover. For additional information, refer to Seat Cushion Cover - Front Seat Cushion Cover - Front.

3. Remove the cushion foam pad.

4. Remove the safety belt buckle and pretensioner.
- Remove the tie strap.

- Disconnect the 2 electrical connectors.

- Remove the nut and safety belt buckle and pretensioner.
- To install, tighten to 55 Nm (41 lb-ft).





5. For driver seat, disconnect the seat track position sensor electrical connector and detach the wiring harness pin-type retainer.

Climate controlled seat

6. Remove the cushion TED.
- Detach the wiring harness and remove the TED.

- Note wire harness routing for correct installation.





7. Release the 2 tabs and slide out the Dual Climate Controlled Seat Module (DCSM).





8. NOTE: When installing a new DCSM, it is necessary to carry out Programmable Module Installation (PMI). For additional information, refer to Module Configuration Programmable Module Installation (PMI).

For passenger seat, remove the DCSM.
- Cut and remove the wire harness tie strap.

- Release the 2 locking wedges.

- Disconnect the 3 electrical connectors.





Power seat

9. If equipped, remove the DSM.
- Disconnect the 4 electrical connectors.

- Release the 2 tabs and slide out the DSM.

10. Disconnect the 3 seat track motor electrical connectors.
- For driver seat with memory, disconnect the 3 additional motor sensor electrical connectors.

11. Remove the wire harness.
- Remove the 3 wire harness bracket screws.

- Remove the tie strap and release the rear wire harness bracket clip from the seat track.

- Separate the electrical connectors and wire harness from the seat track.

- Remove the wire harness and bracket.

- For correct installation, note wire harness routing.

All seats

12. For manual seat, remove the inboard and outboard seat track rails.
- Remove the 6 seat track rail-to-seat track nuts from the inboard and outboard seat track rails.
- To install, tighten to 30 Nm (22 lb-ft).

- Remove the inboard and outboard seat track rails.

- Release and separate the seat track adjust handle from the seat track rails.
- Disconnect the spring.

- Slightly bend the tab and detach the seat adjust handle from the inboard seat track rail.

- Note the spring position for correct installation.





13. To assemble, reverse the disassembly procedure.