Seat Backrest Cover - Second Row, 40 Percent
Seat Backrest Cover - Second Row, 40 Percent
Removal and Installation
1. If equipped, remove the armrest. For additional information, refer to Seat Armrest - Second Row Seat Armrest - Second Row.
2. NOTICE: Use care when releasing the spring clips. They can fall inside the backrest frame.
Remove the head restraint.
- Pull the backrest cover material away from the head restraint guide to access the spring clips.
- Release the 2 spring clips by pushing on the side shown.
- Note the spring clip position for correct installation.
- Raise and remove the head restraint.
3. Position the backrest downward.
4. Remove the kneeling release (cargo mode) handle.
- Raise the handle to access the cable.
- Detach the cable jacket from the kneeling release handle.
- Release the retainers and position aside the kneeling release handle.
5. Release the lower backrest cover J-clip.
6. Position aside the backrest cover rear flap and remove the 4 pin-type retainers.
7. If equipped, disconnect the backrest heater mat electrical connector.
- Release the cushion cover rear J-clip.
- Disconnect the electrical connector.
- Detach the electrical connector and heater mat wiring.
8. Raise the backrest and route the J-clip between the backrest and cushion.
9. NOTICE: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the seat backrest foam pad.
Invert the backrest cover to the row of hog rings.
- Separate the hook-and-loop strips.
- If equipped, route the heater mat wiring through the backrest cover.
10. Remove the row of hog rings.
11. Continue inverting the backrest cover to the head restraint guides.
12. NOTICE: Use care when separating the head restraints and spring clips to avoid tearing or damaging the backrest cover.
Pinch the head restraint guide ends to release and remove the 2 head restraint guides.
13. Remove the backrest cover.
14. To install, reverse the removal procedure.