Seat Track - Power
Seat Track - Power
Removal and Installation
NOTE: If a new Driver Seat Module (DSM) has been installed, all seat and power tilt column (if equipped) soft stops must be reset. If a new seat track, recline motor or power tilt column has been installed, only reset the soft stops for that component being installed new. To reset the soft stops, refer to Principles of Operation. Principles Of Operation
NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.
All seats
1. Remove the affected seat. For additional information, refer to Seat - Front Seat - Front.
2. Remove the seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front Removal and Installation.
3. Remove the safety belt buckle and pretensioner.
- Remove the tie strap.
- Disconnect the 2 electrical connectors.
- Remove the nut and safety belt buckle and pretensioner.
- To install, tighten to 55 Nm (41 lb-ft).
4. Release the cushion cover front and rear J-clips and rear hook-and-loop strip.
Climate controlled seats
5. NOTE: Use care when removing the Thermo-Electric Device (TED). The U-nuts can slip into the cushion frame.
Remove the cushion TED.
- Disconnect the electrical connector and detach the wire harness.
- Remove the 2 screws and TED.
- For correct installation, note wire harness routing.
6. Release the 2 tabs and slide out the Dual Climate Controlled Seat Module (DCSM).
7. NOTE: When installing a new DCSM, it is necessary to carry out Programmable Module Installation (PMI). For additional information, refer to Module Configuration Programmable Module Installation (PMI).
If passenger seat, remove the DCSM.
- Cut and remove the wiring harness tie strap.
- Release the 2 locking wedges.
- Disconnect the 3 electrical connectors.
Driver memory seat
8. Remove the DSM.
- Disconnect the 4 electrical connectors.
- Release the 2 tabs and slide out the DSM.
All seats
9. Remove the cushion frame, foam pad and cushion cover assembly from the seat track.
- Remove the 4 cushion frame-to-seat track bolts.
- To install, tighten to 25 Nm (18 lb-ft).
- Release the 2 cushion frame rear clips and straps from the seat track and remove the cushion frame.
10. Disconnect the 3 seat track motor electrical connectors.
- For driver seat with memory, disconnect the additional 3 motor sensor electrical connectors.
11. Remove the wire harness.
- Remove the 3 wire harness bracket screws.
- Remove the tie strap and release the rear wire harness bracket clip from the seat track.
- Separate the electrical connectors and wire harness from the seat track.
- Remove the wire harness and bracket.
- For correct installation, note wire harness routing.
12. To install, reverse the removal procedure.
- A new seat track will not be equipped with the seat position sensor shunt bracket. The seat position sensor shunt bracket must be removed from the original seat track and transferred to the new seat track.
