Seat - Second Row, 20 Percent

Seat - Second Row, 20 Percent

NOTE: For torque specifications and torque sequence, refer to the procedure steps.











Removal

NOTICE: When removing the seat-to-floor bolt covers, use a flat-blade screwdriver to pry beneath the attaching metal clips or damage to the covers may result.

NOTE: The seat-to-floor bolts must be tightened in the sequence described in this procedure.

1. Fold the LH and RH seats to the E-Z entry position.

2. Remove the 2 right side seat-to-floor bolt covers.

3. Remove the 2 right side seat-to-floor bolts.

4. Remove the left side seat-to-floor bolt cover.

5. Remove the left side seat-to-floor bolt.

6. Position the LH and RH seats upright.

7. Remove the 2 seat-to-floor front bolt covers.

8. Remove the 2 seat-to-floor rear bolt covers.

9. Remove the 2 seat-to-floor front bolts.

10. Fold the LH and RH seats to the E-Z entry position.

11. Remove the LH seat-to-floor rear bolt and then the RH seat-to-floor rear bolt.

12. Remove the seat.

Installation

NOTE: The seat-to-floor bolts must be tightened in the sequence described in this procedure.

1. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Position the seat in the vehicle and align the locator pins to the holes in the floor.

2. Fold the LH and RH seats to the E-Z entry position.

3. Install the seat-to-floor bolts in the following sequence:

1. Install the RH seat-to-floor rear bolt.
- Tighten to 40 Nm (30 lb-ft).

2. Install the LH seat-to-floor rear bolt.
- Tighten to 40 Nm (30 lb-ft).

3. Install the 2 seat-to-floor front bolts.
- Tighten to 40 Nm (30 lb-ft).

4. Install the 3 right and left side seat-to-floor bolts (note, shoulder bolts do not tighten to seat brackets).
- Tighten to 40 Nm (30 lb-ft).

4. Install the 2 seat-to-floor rear bolt covers.

5. Install the 2 seat-to-floor front bolt covers.

6. Install the left and 2 right side seat-to-floor bolt covers.