Component Tests and General Diagnostics
Engine Cooling
Component Tests
Coolant System Pressure Test
WARNING: Always allow the engine to cool before opening the cooling system. Do not unscrew the coolant pressure relief cap when the engine is operating or the cooling system is hot. The cooling system is under pressure; steam and hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may result in serious personal injury.
1. Turn the engine OFF.
2. Remove the pressure relief cap. Fill the radiator with coolant if needed.
3. Fit the Radiator/Heater Core Pressure Tester from the Pressure Test Kit to the radiator fill neck.
4. NOTICE: Do not pressurize the cooling system beyond the maximum pressure listed in the specifications table, or cooling system components can be damaged.
NOTE: If the plunger of the pressure tester is pressed too fast, an erroneous pressure reading will result.
Slowly press the plunger of the pressure test pump to the maximum allowed pressure and hold for 2 minutes. If the pressure drops within this time, inspect for leaks and repair as necessary.
5. If no leaks are found and the pressure drops, the leak may be internal to the radiator transmission cooler. Inspect the coolant for transmission fluid and the transmission fluid for coolant. Repair as necessary.
6. If there is no contamination of the coolant or transmission fluid, the leak may be internal to the engine. Inspect the coolant for engine oil and the engine oil for coolant. Refer to Engine System - General Information Testing and Inspection to diagnose the engine.
Cap
1. Inspect the pressure relief cap and seals for damage or deterioration. Install a new pressure relief cap if necessary.
2. Fit the pressure relief cap to the Pressure Test Kit using the correct adapter.
3. NOTE: If the plunger of the pressure tester is pressed to fast, an incorrect pressure reading will result.
Slowly pump the Pressure Test Kit until the pressure gauge stops increasing and note the highest pressure reading. Release the pressure and repeat the test. Install a new pressure relief cap if the pressure is not within the pressure listed in the specification table.
Thermostat
A new thermostat should be installed only after the following tests and checks have been carried out:
- Pinpoint Test A, B or C
- Thermostat Visual Inspection
Thermostat Visual Inspection
1. Remove the thermostat.
2. Examine the thermostat for signs of damage including:
- Valve not fully seated (light visible through the valve)
- Foreign material lodged in the main valve
- Bent or broken frame or flange
- Bent or broken spring
- Bent or broken valve or valve stem
- Wax leaking from wax reservoir or a bulge in the reservoir
- Any other damage or distortion
3. NOTE: If no damage is found during the inspection, do not attempt to open the thermostat using hot water or other heat sources. This method is not an accurate means to test the function of the thermostat and may damage the thermostat.
If damage is found during the inspection, remove any foreign material or broken pieces and install a new thermostat.
4. If no damage is found during the inspection, continue troubleshooting the system concern. Go to the Symptom Chart for further instructions. Symptom Related Diagnostic Procedures
Radiator Leak Test, Removed From Vehicle
NOTICE: Never leak test an aluminum radiator in the same water that copper/brass radiators are tested in. Flux and caustic cleaners may be present in the cleaning tank and they will damage aluminum radiators.
NOTE: Always install plugs in the transmission fluid cooler fittings before leak testing or cleaning any radiator.
NOTE: Clean the radiator before leak testing to avoid contamination of tank.
Leak test the radiator in clean water with pressurized air to the maximum pressure listed in the Specifications.