Window Glass - Rear Door

Window Glass - Rear Door

Removal and Installation

1. Remove the rear door trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

2. NOTE: There are 2 tabs on the opposite side not shown in the illustration.

NOTE: LF shown, LR and RR are similar.

Unlock the 4 tabs and remove the window control switch from the door trim panel.





3. Position aside the rear door weathershield.





4. Connect the window control switch.

5. Raise or lower the window glass as necessary to access the window glass clamp bolts.

6. Remove the inside glass weatherstrip.





7. Remove the rear door glass channel bolt.
- To install, tighten to 11 Nm (97 lb-in).





8. Loosen the window glass clamp bolts.
- To install, tighten to 11 Nm (97 lb-in).

9. Tape the window in position, then lower the window regulator downward.
- To install, raise the window regulator approximately 2.54 cm (1.0 in) from the full UP position. Then, while manually pushing the glass into the rear channel, raise the window regulator to the full UP position.

10. Lift the window glass out of the door.

11. To install, reverse the removal procedure.