Seat Track

Seat Track

Removal

NOTE: For parts identification and location, REFER to Seat - Exploded View, Front Seat - Exploded View, Front.

1. Remove the safety belt buckle and pretensioner. REFER to Safety Belt Buckle and Pretensioner Safety Belt Buckle and Pretensioner.

2. Remove the seat backrest. REFER to Seat Backrest Seat Backrest.

3. Remove the seat cushion cover. REFER to Seat Cushion Cover Seat Cushion Cover.

4. If equipped, remove the seat cushion TED (Thermo-Electric Device). REFER to Seat Cushion Thermo-Electric Device (TED) Seat Cushion Thermo-Electric Device (TED).

5. If equipped, remove the DSM (Driver Seat Module). REFER to Driver Seat Module (DSM) Seating - 1st Row.

6. If equipped, remove the DCSM (Dual Climate Controlled Seat Module). REFER to Dual Climate Controlled Seat Module (DCSM) Service and Repair.

7. Remove the seat position sensor in the following sequence:

1. Disconnect the seat position sensor electrical connector.

2. Pull the locking tab downward to disengage.

3. Slide the seat position sensor backward to disengage and remove it from the seat track bracket.

8. NOTE: Note the wire harness routing for installation.

If equipped, disconnect the cushion heater mat electrical connector, located at the front of the seat track, and separate the wire harness retainer.





9. Remove the cushion foam pad from the cushion frame.

10. NOTE: Power seat track on top, manual seat track on bottom.

For a passenger seat, remove the OCSM (Occupant Classification System Module) in the following sequence:

1. Disconnect the electrical connector.

2. NOTE: For manual seat track only.

If equipped, bend the locking tab downward.

3. Remove the 2 screws.





11. NOTE: Power seat track on top, manual seat track on bottom.

For a passenger seat, separate the pressure sensor in the following sequence:

1. Bend the locking tab downward.

2. Slide the pressure sensor off of the bracket.

3. Disconnect the electrical connector.





12. For a passenger seat, detach the OCS (Occupant Classification System) bladder pin-type retainers.





13. NOTE: Power seat track on top, manual seat track on bottom.

For a passenger seat, route the OCS (Occupant Classification System) hose and pressure sensor through the cushion support wires.





14. Remove the 3 screws and 2 pin-type retainers and remove the LH (Left Hand) and RH (Right Hand) seat track covers.

15. NOTE: Note the seat cushion wire harness routing for installation.

Remove the seat cushion wire harness.

Installation

1. To install, reverse the removal procedure.