Compressor to Condenser Discharge Line

Compressor to Condenser Discharge Line - 3.5L Ti-VCT

Material(s)






Exploded View










Removal

1. Recover the refrigerant. REFER to Air Conditioning (AC) System Recovery, Evacuation, and Charging Air Conditioning (AC) System Recovery, Evacuation, and Charging.

2. Remove the rear A/C compressor bolt.

3. Remove the A/C compressor discharge fitting nut and disconnect the fitting.

- Discard the O-ring seal and gasket seal.

4. Disconnect the A/C pressure transducer electrical connector.

5. Remove the condenser inlet fitting nut and disconnect the fitting.

- Discard the O-ring seal and gasket seal.

6. Remove the compressor-to-condenser discharge line.

Installation

1. Install the compressor-to-condenser discharge line.

2. Using a new O-ring seal, connect the condenser inlet fitting and install the nut.

- Tighten to 15 Nm (133 lb-in).

3. Connect the A/C (Air Conditioning) pressure transducer electrical connector.

4. Using a new O-ring seal, connect the A/C (Air Conditioning) compressor discharge fitting and install the nut.

- Tighten to 15 Nm (133 lb-in).

5. Install the rear A/C (Air Conditioning) compressor bolt.

- Tighten to 25 Nm (18 lb-ft).

6. Recharge the A/C (Air Conditioning) system. REFER to Air Conditioning (AC) System Recovery, Evacuation, and Charging Air Conditioning (AC) System Recovery, Evacuation, and Charging.