Power Running Board (PRB)

Power Running Board (PRB)









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. NOTE: If the Power Running Board (PRB) cannot be extracted, extend the running board by hand.

Extend the PRB.

3. Disconnect the PRB electrical connector.

NOTICE: The following steps require an assistant. Failure to follow this instruction may result in damage to the vehicle.

4. Remove the PRB assembly front bracket upper bolts.
- To install, tighten to 22 Nm (16 lb-ft).

5. Remove the PRB assembly front bracket lower bolts.
- To install, tighten to 22 Nm (16 lb-ft).

6. Remove the PRB assembly rear bracket upper bolts.
- To install, tighten to 22 Nm (16 lb-ft).

7. Remove the PRB assembly rear bracket lower bolts.
- To install, tighten to 22 Nm (16 lb-ft).

8. Remove the PRB assembly.

9. To install, reverse the removal procedure.