Seat Latch - Front, Center

Seat Latch - Front, Center

Removal and Installation

NOTE: For parts identification and location, refer to Seat - Exploded View, Front, Center Seat - Exploded View, Front, Center.

1. Remove the seat. For additional information, refer to Seat - Front, Center Seat - Front, Center.

2. Remove the rear cupholder.
- Remove the 2 rear cupholder screws.

- If equipped, disconnect the power point electrical connector.

3. Remove the backrest latch cover.

4. Remove the RH side shield.
- Release the pin-type retainer.

5. Remove the 2 backrest latch upper bolts.
- Lower the backrest to avoid damaging the pivot side.

- To install, tighten to 60 Nm (44 lb-ft).

6. Remove the 2 backrest latch lower bolts and backrest latch.
- To install, tighten to 45 Nm (33 lb-ft).

7. To install, reverse the removal procedure.