Selector Lever - Floor Shift

Selector Lever - Floor Shift









Removal

1. Using a suitable tool, remove the instrument panel to floor console finish panel.





2. Remove the floor console upper finish panel.
- Starting at the rear of the upper finish panel, carefully pry up the upper finish panel and disconnect the electrical connectors.





3. Disconnect the selector lever cable from the selector lever arm.





4. NOTE: The selector lever bezel has been removed for clarity. Do not remove the selector lever bezel.

Remove the 4 selector lever assembly bolts.





5. Disconnect the selector lever cable from the selector lever cable bracket.





6. Disconnect the selector lever harness connector and remove the selector lever from the vehicle.





Installation

1. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket.

Install the selector lever cable in the selector lever cable bracket.





2. Position the selector lever assembly in the console and install the 4 bolts.
- Tighten to 8 Nm (71 lb-in).





3. Connect the selector lever harness connector.





4. Connect the selector lever cable onto the selector lever arm.
- Listen for the audible click.

- Pull back on the selector lever cable to make sure that it is installed correctly.





5. Connect and install the floor console upper finish panel.





6. Install the instrument panel to floor console finish panel.