Antenna Cable - Satellite Radio

Antenna Cable - Satellite Radio









Removal and Installation

NOTE: For vehicles with navigation, a splitter is built-in to the lower satellite radio antenna cable to split the satellite radio and Global Positioning System (GPS) signals.

Both cables

1. Lower the glove compartment completely.

2. Disconnect the upper-to-lower satellite radio antenna cable connection.

Upper cable

3. Remove the RH A-pillar trim panel. For additional information, refer to Interior Trim and Ornamentation A-Pillar Trim Panel.

4. Remove the 3 screws, the RH sun visor retaining clip, and the RH sun visor.
- If equipped, disconnect the electrical connector.

5. Lower the front of the headliner enough to gain access to the satellite radio antenna electrical connector.

6. Remove the upper satellite radio antenna cable.
- Disconnect the electrical connector.

- Separate the pushpins from the A-pillar and instrument panel.

Lower cable

7. Remove the Audio Control Module (ACM). For additional information, refer to Audio Control Module (ACM) Audio Control Module (ACM).

8. Remove the lower satellite radio antenna cable.
- Disconnect the electrical connector.

- Separate the pushpins from the instrument panel.

Both cables

9. To install, reverse the removal procedure.