Pinpoint Test F: The Speedometer Is Inoperative

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test F: The Speedometer Is Inoperative

Normal Operation

The Instrument Panel Cluster (IPC) receives the vehicle speed signal from the PCM over the High Speed Controller Area Network (HS-CAN). The PCM receives the vehicle speed signal input from the transmission Output Shaft Speed (OSS) sensor. The IPC monitors the vehicle speed signal input from the PCM and commands the speedometer with a corresponding movement of the pointer.

If the IPC receives invalid vehicle speed data from the PCM for 5 seconds or less, the IPC defaults the speedometer to the last setting, based upon the last known good vehicle speed message. If the IPC does not receive the vehicle speed data from the PCM for more than 5 seconds, the IPC sets DTC U0100:00 in continuous memory and defaults the speedometer to 0 km/h (0 mph). If the vehicle speed data received is deemed invalid by the IPC, the IPC sets DTC U0401:00 and defaults the speedometer to 0 km/h (0 mph).

NOTE: If DTC U0100:00 sets in the IPC, other observable symptoms may be an inoperative tachometer, temperature gauge or odometer.

This pinpoint test is intended to diagnose the following:

- PCM
- IPC

PINPOINT TEST F: THE SPEEDOMETER IS INOPERATIVE

-------------------------------------------------
F1 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST

- Check the recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
- Are any DTCs recorded?

Yes
REFER to Computers and Control Systems. TEST the system for normal operation.

No
GO to F2.

-------------------------------------------------
F2 CARRY OUT THE SPEEDOMETER ACTIVE COMMAND USING THE SCAN TOOL

- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IPC DataLogger.
- Select the IPC speedometer (SPDOMETER) active command. Command the speedometer on and off while monitoring the speedometer.
- Does the speed begin at 0 km/h (0 mph) move to 193 km/h (120 mph) and return to 0 km/h (0 mph)?

Yes
GO to F3.

No
INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.

-------------------------------------------------
F3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST

- Check for recorded IPC DTCs from the self-test.
- Are any DTCs recorded?

Yes
For DTC U0100:00, GO to Pinpoint Test AT Pinpoint Tests AT: DTC U0100:00. For all other DTCs, REFER to DTC Charts. Instrumentation, Message Center and Warning Chimes

No
INSTALL a new PCM. REFER to Electronic Engine Controls Service and Repair. TEST the system for normal operation.

-------------------------------------------------