Starter Motor: Service and Repair

Starter Motor - 5.0L (4V), 6.2L (2V)





Item Part Number Description

1 11N087 Terminal cover

2 W705790 Starter solenoid S-terminal nut

3 14463 Starter solenoid S-terminal eyelet

4 W706414 Starter solenoid B+ terminal nut

5 14463 Starter solenoid B+ terminal eyelet

6 N805024 Starter motor ground cable nut

7 14463 Starter motor ground cable eyelet

8 W704941 Starter motor mounting stud bolt

9 W704942 Starter motor mounting bolts (2 required)

10 11002 Starter motor

Removal and Installation

WARNING: Always disconnect the battery ground cable at the battery before disconnecting the starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle jacking and lifting.

2. Disconnect the battery ground cable. For additional information, refer to Battery.

3. Remove the terminal cover.

4. Remove the nut and disconnect the starter solenoid S-terminal eyelet.

- To install, tighten to 5 Nm (44 lb-in).

5. Remove the nut and disconnect the starter solenoid B+ terminal eyelet.

- To install, tighten to 12 Nm (106 lb-in).

6. Remove the nut and disconnect the starter motor ground cable eyelet.

- To install, tighten to 25 Nm (18 lb-ft).

7. NOTE: Tighten the upper bolt before tightening the lower fasteners.

Remove the stud bolt, the 2 bolts and the starter motor.

- To install, tighten to 25 Nm (18 lb-ft).

8. To install, reverse the removal procedure.