Heated Seat Module - Rear

Heated Seat Module - Rear

Removal

NOTE: For parts identification and location, refer to Seat - Exploded View, Rear, Crew Cab Seat - Exploded View, Rear, Crew Cab.

1. NOTE: The seat backrest latch is only accessible when the seat cushion is raised.

Release and lower the 60 percent seat backrest.

- From behind the backrest, pull up on the latch release and pull the backrest forward.

- Release the cushion latch and lower the cushion and backrest.





2. Disconnect the 2 electrical connectors.

3. Remove the screw and un-hook the heated seat module.

Installation

1. Install the heated seat module and screw.
- Tighten to 14 Nm (124 lb-in).

2. Connect the 2 electrical connectors.

3. Raise and latch the backrest.
- Slide the striker pin up/down and align to the backrest latch.

- Make sure the backrest is fully latched.

4. Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
- Start the vehicle and push the low button on either heated seat switch.

- Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.