B-Pillar Trim Panel - SuperCrew

B-Pillar Trim Panel - SuperCrew

Removal and Installation

1. Position seats fully down and forward.

2. Depower the Supplemental Restraint System (SRS). For additional information, refer to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

3. Pull upward to release the scuff plate clips and remove the front door scuff plate.
- Detach the scuff plate from the weatherstrip.





4. Position the front and rear weatherstrips aside.

5. Remove the safety belt D-ring trim cover.

6. Remove the safety belt D-ring bolt.
- To install, tighten to 40 Nm (30 lb-ft).

7. NOTE: Starting at the top of the cover, use a non-marring tool.

Remove the B-pillar bolt cover.

8. Remove the B-pillar bolt.





9. Remove the safety belt anchor bolt trim cover.





10. Remove the safety belt anchor bolt.
- Disconnect electrical connector.

- To install, tighten to 40 Nm (30 lb-ft).

11. Pull upward to release the scuff plate clips and remove the rear door scuff plate.
- Detach the scuff plate from the weatherstrip clip.





12. Remove the safety belt trim ring and pull the safety belt through the B-pillar.





13. Remove the B-pillar trim panel.

14. NOTE: The B-pillar trim panel has a 2-way locator and a 4-way locator that must be positioned correctly on installation.

To install, reverse the removal procedure.