Selector Lever Cable - Column Shift

Selector Lever Cable - Column Shift

NOTE: Click here or refer to the on-line diagnostic/repair information to view this illustration as an interactive exploded view, requires Adobe(R) Acrobat(R) 8.0 or higher.

NOTE: Click here or refer to the on-line diagnostic/repair information to learn about using an Interactive Illustration.









Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the steering column shrouds. For additional information, refer to Steering Column Steering Column Shroud.

3. Position the selector lever into the D position.

4. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the selector lever mechanism and the steering column bracket.

Disconnect the selector lever cable from the steering column.

1. Disconnect the selector lever cable from the selector lever mechanism.

2. Carefully lift the locking tab and disconnect the selector lever cable from the steering column bracket.

3. Disconnect the selector lever cable retainer.





5. Push the rubber grommet and selector lever cable through the floor pan.





6. Detach the selector lever cable from the routing clip.





7. If equipped, remove the nut and the selector lever cable splash shield.





8. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the manual control lever and the selector lever cable bracket.

Disconnect the selector lever cable from the manual control lever.





9. Remove and discard the selector lever cable retaining clip.
- Lift the lock tabs on the retaining clip arms to release the clip. Pull the clip and selector lever cable from the selector lever cable bracket.





10. Remove the selector lever cable.

Installation

1. Place the manual control lever in the (D) position.

1. Rotate the manual lever counterclockwise 3 detents into the manual 1st position.

2. Rotate the manual lever clockwise 3 detents into the (D) position.





2. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket.

Install the selector lever cable into the selector lever cable bracket and install a new retaining clip.





3. Connect the selector lever cable onto the manual control lever.





4. Attach the selector lever cable to the routing clip.





5. Push the rubber grommet and selector lever cable up through the floor pan.





6. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket.

Connect the selector lever cable onto the steering column.

1. Connect the selector lever cable retainer.

2. Connect the selector lever cable onto the steering column bracket.

3. Connect the selector lever cable onto the selector lever mechanism.
- Listen for the audible click.

- Pull back on the selector lever cable to make sure that it is correctly installed.





7. Install the steering column shrouds. For additional information, refer to Steering Column Steering Column Shroud.

8. Adjust the selector lever cable. For additional information, refer to Selector Lever Cable Adjustment - Column Shift Selector Lever Cable Adjustment - Column Shift.