Selector Lever Cable - Floor Shift

Selector Lever Cable - Floor Shift

NOTE: Click here or refer to the on-line diagnostic/repair information to view this illustration as an interactive exploded view, requires Adobe(R) Acrobat(R) 8.0 or higher.

NOTE: Click here or refer to the on-line diagnostic/repair information to learn about using an Interactive Illustration.









Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Using a suitable tool, remove the instrument panel to floor console finish panel.





3. Remove the floor console upper finish panel.
- Starting at the rear of the upper finish panel, carefully pry up the upper finish panel and disconnect the electrical connectors.





4. NOTE: The selector lever bezel has been removed for clarity.

Disconnect the selector lever cable from the selector lever arm.





5. Remove the center console LH kick panel.





6. Disconnect the selector lever cable from the selector lever cable bracket.





7. Push the rubber grommet and selector lever cable through the floor panel.





8. Detach the selector lever cable from the routing clip.





9. If equipped, remove the nut and the selector lever cable splash shield.





10. NOTE: The 3.5L is shown. The 3.7L, 5.0L and 6.2L do not have a heat shield.

Clean cable adjustment lock of any debris.





11. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket.

Move the locking tab up and disconnect the selector lever cable from the manual control lever.





12. Remove the selector lever cable from the selector lever cable bracket.





Installation

1. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket.

NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket.

Attach the selector lever cable to the selector lever cable bracket.





2. Connect the selector lever cable onto the manual control lever and move the locking tab down.
- Listen for the audible click, then push back on the locking tab to verify it is locked.

- Pull back on the selector lever cable to verify it is installed correctly to the manual lever.





3. Attach the selector lever cable to the routing clip.





4. Install the rubber grommet and selector lever cable through the floor panel.





5. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket.

Connect the selector lever cable onto the selector lever.

1. Connect the selector lever cable onto the selector lever cable bracket.

2. Connect the selector lever cable onto the selector lever arm.
- Listen for the audible click.

- Pull back on the selector lever cable to make sure that it is installed correctly.





6. Install the center console LH kick panel.





7. Connect and install the floor console upper finish panel.





8. Install the instrument panel to floor console finish panel.





9. Adjust the selector lever cable. For additional information, refer to Selector Lever Cable Adjustment - Floor Shift Selector Lever Cable Adjustment - Floor Shift.