Crew Cab

Seat Cushion - Rear, Crew Cab

Removal and Installation

1. Remove the seat. For additional information, refer Seat - Rear, Crew Cab Crew Cab to.

2. Remove the 2 bolts from the back side of the center support.
- To install, tighten to 50 Nm (37 lb-ft).

3. Separate the 60 percent seat from the center support.

4. Remove the screw and side latch shield.

5. Remove the screw and cushion release handle.

6. Pry the side shield to release the 3 clips and remove the side shield.

7. Remove the 2 outboard cushion latch-to-cushion bolts and the cushion assembly.
- To install, tighten to 33 Nm (24 lb-ft).

8. Remove the outboard cushion latch lower mount bolt and the seat cushion latch assembly.
- To install, tighten to 25 Nm (18 lb-ft).

9. To install, reverse the removal procedure.