Crankshaft Position Sensor

Engine Control Components - Exploded View





Crankshaft Position (CKP) Sensor

NOTE: The red locking tab on the Crankshaft Position (CKP) sensor electrical connector must be released prior to disconnecting the CKP sensor. Engage the red locking tab after connecting the CKP sensor electrical connector.

NOTE: Lubricate the Crankshaft Position (CKP) sensor O-ring seal with clean engine oil prior to installation.









Removal and Installation

NOTICE: Do not use silicone based sprays or lubricants on any components installed onto or around the diesel exhaust system or intake air distribution and filtering system. Silicone reacts with the Nitrogen Oxides (NOx) sensor and may cause permanent damage to the NOx sensor.

NOTICE: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or damage to the vehicle may occur.

1. Refer to the procedures and/or exploded views for any Warnings, Notices, Notes, Materials, Specifications, and Special Tools. Items in the exploded views may not be listed in order of removal.