22500 MI or 36000 KM
InspectWheels
Inspect wheels and related components for abnormal noise, wear, looseness or drag, if not using Special Operating conditions.
Vehicle
Perform multi-point inspection (recommended).
Universal Joint, Drive/Propeller Shaft
Inspect and Lubricate U-joints and if using Special Operating conditions D and O.
Tie Rod End
Inspect and lubricate ball joints and tie rods (if equipped with grease fittings) and if using Special Operating conditions D and O.
Steering and Suspension
Inspect and lubricate steering linkage.
Fluid - A/T
Inspect automatic transmission fluid level.
Exhaust System
Inspect exhaust system and heat shields.
Brakes and Traction Control
Inspect brake pads, shoes, rotors, drums, brake linings, hoses, and parking brake, if not using Special Operating conditions or if using Special Operating conditions D and O.
Ball Joint
Inspect and lubricate ball joints and tie rods (if equipped with grease fittings) and if using Special Operating conditions D and O.
Air Cleaner Restriction Indicator
Inspect air filter restriction gauge, replace filter as necessary, if not using Special Operating conditions.
Replace
Oil Filter, Engine
Change engine oil if not using special operating conditions and if using Special Operating conditions D and O.
Fuel Filter
Replace engine- and frame-mounted fuel filters, if not using Special Operating conditions.
Engine Oil
Change engine oil every 2500 miles (4000 km) or 3 months (if using high sulfur fuel with more than 500 ppm sulfur), if use of non-Ultra Low Sulfur Diesel (ULSD) fuel-Vehicles operated where ULSD fuel is not required/not available. Change engine oil if not using special operating conditions and if using Special Operating conditions D and O.
Rotate
Tires
Rotate tires, inspect tire wear and measure tread depth, if not using Special Operating conditions. Vehicles equipped with dual rear wheels should only rotate if unusual wear is observed.