Pinpoint Tests AZ: The Turn Signal On Warning Chime Is Inoperative
Instrumentation, Message Center and Warning Chimes
Pinpoint Tests
Pinpoint Test AZ: The Turn Signal On Warning Chime Is Inoperative
Normal Operation
The turn signal on warning chime sounds when the vehicle travels more than 3.2 km (2.0 miles) with the turn signal on. The Body Control Module (BCM) communicates the turn signal switch status to the IPC over the High Speed Controller Area Network (HS-CAN) communication bus. The PCM communicates the odometer count data to the IPC over the HS-CAN communication bus.
This pinpoint test is intended to diagnose the following:
- Odometer operation
- Turn signal indication concern
- BCM
- IPC
PINPOINT TEST AZ: THE TURN SIGNAL ON WARNING CHIME IS INOPERATIVE
-------------------------------------------------
AZ1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- With the ignition switch in the OFF position and the key in the ignition lock cylinder, open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?
Yes
GO to AZ2.
No
INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.
-------------------------------------------------
AZ2 CHECK THE TURN SIGNAL INDICATORS OPERATION
- Ignition ON.
- Verify the turn signal indicators operation.
- Do the turn signal indicators operate correctly?
Yes
GO to AZ3.
No
GO to Pinpoint Test T. Pinpoint Test T: The LH/RH Turn Or High Beam Indicator Is Never/Always On
-------------------------------------------------
AZ3 CHECK THE ODOMETER FOR CORRECT OPERATION
- Drive the vehicle and observe the odometer for correct operation.
- Does the odometer operate correctly?
Yes
INSTALL a new BCM. REFER to Multifunction Electronic Modules Service and Repair. TEST the system for normal operation.
No
GO to Pinpoint Test I. Pinpoint Test I: The Odometer Is Inoperative
-------------------------------------------------